Error 1: “ID not found” when read eeprom 95160
I connect usb cable with carprog and a6 clip to eeprom 95160 . it gives me error “ID not found” .

carprog-eeprom-95160-id-not-found-1-1024x606
carprog-eeprom-95160-id-not-found-2
Solution 1: Desoldering the eeprom from circuit board and read not in circuit board, read eeprom on the table
carprog-eeprom-95160-id-not-found-3
Error 2: “Verify error” when read eeprom 95160
Read with A6 clip. There is an error
carprog-eeprom-95160-id-not-found-4
Solution 2: Take a look here
carprog-eeprom-95160-id-not-found-5
carprog-A6-SOIC8-Clip-wiring-2-735x1024
carprog-A6-SOIC8-Clip-wiring-3
Error 3: “Verify OK” when read eeprom; “Verify error” when write it
if i read it, verify ok
carprog-eeprom-95160-verify-ok-1
If write it, verify error
carprog-eeprom-95160-verify-error-write
Solution 3:
probably have a damaged carprog.
Replace 74hc125.
try reading with the power supply.
Use a4 adapter
carprog-EEPROM-A4-WIRING-MANUAL
Here is a Picture of wires from chinese Carprog A4 Adapter
1. Blue
….
8. Purple
china-carprog-a4-adapter-wiring-1
china-carprog-a4-adapter-wiring-2
In summary,

 

The best, safest, faster and simplest solution is to remove the eeprom from the PCB and use the carprog eeprom adapter .
in this way, all possible problems are avoided.

carprog-eeprom-easy-solution-1
china-carprog-a4-adapter-wiring-3

Case: Carprog reads/writes eeprom 95160

Car: bsi citroen berlingo 2004
Eeprom: 95160

4
carprog-eeprom-95160-2
carprog-eeprom-95160-3
5
carprog-eeprom-95160-5
carprog-eeprom-95160-7
carprog-eeprom-95160-8
carprog-eeprom-95160-9
carprog-eeprom-95160-10
Carprog programmer manages to change mileage successfully on citroen berlingo 2004